Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
any machinist types? sleeve question
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="sr5bidder, post: 1365917, member: 98736"] yeah I though so too but on the "m" piston instruction sheet from wiesco the instructions say use the factory clearances for both plated and sleeved pistons... I believe what your saying ...my kdx never ran good untill it was warmed up all the way. I can fit a .20mm feeler between my piston and sleeve so to be safe I will probably go with a .50 oversize cause a .25 would probably fit in now with out machining [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
any machinist types? sleeve question
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom