Reply to thread

Message: [QUOTE="Brandon H., post: 1382656, member: 104478"] According to the manual, it looks like 15mm from the top of the float, to the mating surface of the carb. I guess being carefully to not compress the small plunger on the needle. I like the clear hose idea. I think I may try it. But where should the fuel be? your saying a few MM below mating surfaces is good, but what if its a tad bit higher or lower. Is this a accurate enough test? I too think its running really rich on the bottom end. Pilot jet is a #50, what size would this be when ordering a couple smaller jets? I noticed they go like 12.5, 15....and so on. [/QUOTE]