Reply to thread

Message: [QUOTE="2-strokes-4-life, post: 1029151, member: 59519"] i got the bike back together and rode it for a day or so and noticed a rattle type sound at low rpm.i was told not to worry about it and the bike makes great power,but i started noticing coolant leaking from the back of the cylinder head as well as alittle spot of oil underneath the hole where the head stay bolt goes through the head.i went to check the cylinder head nuts to see if any were loose and the one at the rear would tighten up to a point but then just keep on spinning.at that point i noticed the hole stud was loose and coolant started shooting up past the stud.i thought it was stripped but luckily it just broke in two.half is still in the cylinder and the rest is in the head.whats the best way to get the stud out without removing the cylinder?can i just tape off all the opening's and use an easy out? [/QUOTE]