Reply to thread

Message: [QUOTE="SFO, post: 134624, member: 21864"] Rich, super thanks for the hook up. I have the 97mm piston kit ala Gore/Rohrich for my 426. I sent my cams to falicon for the vernier sprockets, and have my piston on the rotary table to pull some of the weight out of it. Is there an advantage to the weisco untapered wrist pin? Or can I machine the taper into it? I am going to set up the squish with the cylinder .010" under the deck, the cometic gasket sets up around .040" right? The hone finish that us chrome is using now looks 100% better than a few years ago. It is obvious they got some new equipment. Should I machine the head surface or do you recommend the oem volume. I don't have a burret(sp?) to check the volume. Thanks again for your help Rich, This is getting interesting...:) [/QUOTE]