Reply to thread

Message

[QUOTE="mike-evans, post: 1371993, member: 110699"]
right on my 01 yz 250 i bled my rear brake earlier, stinking fluid came out, nice new clean fluid in there, feels ok  :) . Fitted brand new pads on the front, but disc needs replacing, it has worn a groove in the centre where the pads contact, so i attempted the front, and couldnt get it to feel solid, stil a litle spongey  :( ...air in system? I noticed when i had a clear pipe on the bleed nipple going into a jar of fluid, when i pump the lever, hold the lever, open nipple, close nipple, release lever then i could see the fluid going back up the pipe as if its going back into the caliper...i also noticed when i look into the master cylinder with the top off it, the hole where the fluid goes through with the litle flap type seal if i squeeze the brake hard i would get a bubble up out of that hole, does that mean i need a caliper/master cylinder seal kit? No leaks at all on caliper or master cylinder, could the spongey be due to worn disc? Any ideas?
[/QUOTE]

Verification

Which ocean is California closest to?