Reply to thread

Message

[QUOTE="cooldude3552000, post: 1046156, member: 63544"]
well I finally got my bike running(92 Yamaha wr200),  Long story short, I rebuilt the engine, screwed up and had to get cylinder re-sleeved and buy new piston, I also had to replace power valve assembly(turns out it has never worked).  I then rebuilt it the right way and put it back together.  All that took 2 months!

I just took it out for the first time. I ran it for about 8-10 minutes, no higher than 3rd gear and low RPM.  I am letting it cool down and will take it out again for 8-10 minutes but push it a little harder in higher gears. then repeat with bursts of full throttle. Then according to the manual I'm done.
Is there anything else I should be doing.

I am running "Gold Spectra"(think that's what it's called) oil (52:1) with 93 octane fuel(the man who re sleeved the engine said to do this).  The only mods to this bike are UNI air filter and boyesen power reeds(both installed during rebuild, first time running with them).  I leaned out pilot screw just enough so it runs and doesn't smoke a lot.

When i was running the engine seemed a little rough(improved slightly by end of run), is this normal for break in?

Please respond.
Thanks!
[/QUOTE]

Verification

Which ocean is California closest to?