Reply to thread

Message: [QUOTE="Paulathin, post: 1353184, member: 104262"] ok if what that guy said doesnt stop the carb from leaking...take th carb apart get the bowl and take the little pin out from where it holds the float on. take the needle off the float and turn the float over and look at where the niddle would usually sit. if there is a tiny little indent then that will make the gas leak...i had that problem and i sanded the little bump down.. that only worked for a little while.. then it leaked again so i put J-B Weld on the hole and let it dry after it dried i sand the extra JB off. i left a little on and i just adjusted the float to the new hirght that the JB makes.Make sure there isnt a hole in the float also. and also make sure the floats r level after you are done. HAHAHA i hope that helps. i had trouble for a while with it and yes that is alot to read. If you have any other questions about the freaking novel i wrote just coment back. ahah i hope that helps [= [/QUOTE]