Carb needle/float settings KDX200 E4

[GrayH]

Hi
Could anyone tell me the standard needle position (currently bottom of 5) for a 92 KDX200 (UK). It currently starts just a little too willingly and the needle position is obviously at its richest at the moment.
Also the float height is currently 6mm from the mating face to the joint line on the side of the float.
Could anyone with a manual confirm the standard settings.
All the main/pilot jets are standard.
Thanks
Graham

 

[Dewster]

Go to www.buykawasaki.com and check out the parts diagram for your bike. Everything you're asking is there.

http://justkdx.dirtrider.net/ will also answer you question on float level in detail.

http://www.frpoffroad.com/ is also a good KDX resource.

 

[GrayH]

Thanks Dewster
Have already check kawasaki.com but it doesnt show the standard needle setting. As everything else in the carb is standard it just seemed odd that the needle should be set so high.
Have read the Tech article and the float height is good!
thanks again
Graham