Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
Cause of governor lever failure???
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="xpwarrior, post: 78717, member: 21365"] Picked up a new governor lever today and I will be taking the top end apart tonight to clean the KIPS valves. Just wondered why the governor lever was so prone to failure. Mine was broke when I got the bike so I don't know what caused it. Is it most likely failure to support the governor shaft when tightening the left-hand nut? Will running the bike with the valves stuck break the lever? Since i'm doing all the work to get KIPS running again i'd just like to make sure it stays that way. :) Also does just the very end of the governor shaft fit into the slot on the governor. I couldn't see any way to change the fit but had just figured it would engage it a little farther. No more leverage than this system has I better make sure the valves move smooth as silk. Thanks Jason [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
Cause of governor lever failure???
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom