Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Clutch drags
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="Rcannon, post: 965697, member: 26263"] Look at the clutch arm as it leaves the case. Is it pointing foreward?? Most of the YZ from 97 and 98 do this. In this position it is almost impossible to release the clutch. Aftermarket perches make the problem worse. I used a shim from the 250f bikes. Put it on the clutch side of the rod that runs through the case. This rod is too short. Something 2.5 to 3mm thick will help a lot. Your clutch basket and inner hub is probably grooved. Combine all of these issues and the clutches get really bad. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Clutch drags
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom