Reply to thread

Message: [QUOTE="dwiggins, post: 1419964, member: 77461"] There was a little "notching" on the hub where each tab sits so I used a file and cleaned each one up a little. I do that every time I put one in. I haven't messed with the lever, but did check it out and its working fine. I did put a little extra oil in the trans thinking that with everything dry it would end up ok. I read in the service manual that it might make it drag. I'll lower it to the right level and see what happens. When I started it the first time, I took it for a ride around the yard. Then parked it at the bottom of a jump and slipped the clutch while giving it throttle thinking it may have a dry plate sticking. Didn't change a thing. rode it for 5 min. pulling the clutch in and reving it about 50 times. Still drags. Think I'll try the old friction plates. I will measure them first. I do have a set of calipers. I'll post what I find. [/QUOTE]