Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
CR 250 forks... Special tools???
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="94formy, post: 1086367, member: 67847"] I did a search but didn't find anything. Im getting ready to do the fork seals on my 93 CR 250 and in the book it says i need a couple special tools. I know i need a seal driver but can I just cut one of my old seals and use that? Also it says i need a fork slider spacer?? How necessary is that and what exactly is it for? The book doesnt say much about it. It also says I need a damper rod holder. Do I have to go to honda and buy these tools, can it be done without them, or is there a cheap alternative where i can make my own. If i knew the purpouse of what the slider spacer adn the dampener rod holder was then I could probabally fabricate my own. Any help would be GREATLY apprecaited. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
CR 250 forks... Special tools???
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom