Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Dirt Bike Brands - Other
CR exhaust valve governor setup
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="QuentinCR250, post: 1055016, member: 61111"] Just put the clutch, kickstarter assembly, gearshift linkage and exhaust valve governor back into the right case after a bottom end rebuild, all went well except my Clymer manual gave no indication of which slot in the rack the pinion shaft for the powervalve should engauge into and which position the top of the shaft shoul be. In the end I figured what position the top of the shaft should face but still was not 100% sure where on the rack the pinion should engauge. anyone have any advise? did a search but could only find stuff relating to cylinder installation and not the governor/pinion shaft itself. thanks [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Dirt Bike Brands - Other
CR exhaust valve governor setup
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom