Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Crank seals and head gaskets
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="kawdude, post: 732510, member: 42343"] I'm starting to reassemble my engine and have a question about installing the lower seals and bearings. Early I heated the case in the oven to 300 degrees for 12 minutes and the bearings would not drop into the case. How hot and how long should the case be heated for the bearings to drop in. Will this effect the rubber on the seals? Also, how do I know the seals are all the way in? I put mine in and they appear to have bottomed but there is still some sticking up on the inside of the case. Is this normal? My concern is that the part of the seal on the inside is partially blocking the oil hole from the cylinder. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Crank seals and head gaskets
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom