Reply to thread

Message: [QUOTE="crf250r1, post: 1429122, member: 124007"] Okay, so I tried to kick my bike over again and it sounded like it was not getting fuel, I pulled the plug out and discovered the bike shop had put in a cheap plug for a 2004 not 2006, I checked plug and it seemed very dry, no fuel on it, I went to shop and bought correct $60 plug, tried to kick it over and still nothing, took plug out and still seemed dry, took valve cover off and noticed some light scratches on the underneath of the cover where it has the alloy plate, not sure if that is okay? I put cover back on and tightened up without torque wrench, does this matter? Next I rolled the bike on flat ground running next to it and jumped on and put it in 2nd gear and it fired straight away, let it run for 5 minutes and turned it off, tried to kick it again and it kept back firing which it has never done before, Also top end sounded very tappity, any ideas [/QUOTE]