Cylinder Head O-Rings - Help!

B

bk250

Member

Sep 6, 2006

26

0

• May 11, 2007

• #1

Silly question so forgive me. Do any of you have tips or advice on how to get the 2 o-rings back into the cylinder head? I took them out to clean the cylinder and cannot get them back in. They almost appear to be a little too large and end up with a bubble on one side that just won't go back down into the groove on the cylinder.

Am I correct in assuming that new rings would fit better? I would prefer to avoid that right now because the bike has already been torn apart for over a week waiting for a part and having to order these rings would cost me another week.

 

7

76GMC1500

Uhhh...

Oct 19, 2006

2,142

1

• May 11, 2007

• #2

O-rings do sometimes expand, especially when exposed to gas. It might be wise to get a new pair.

 

IndyMX

Crash Test Dummy

~SPONSOR~

Jul 18, 2006

5,548

2

Amo, IN

• May 11, 2007

• #3

And since most bike shops can't seem to have stuff like that on hand, might be wise to go ahead and order 2 sets..

 

C

Charlie Mix

Member

Feb 7, 2007

38

0

• May 11, 2007

• #4

This info don't help you because of the time needed but anyway:
Leave them apart for 1 week and they will take back their shape.

 

A

adam728

Member

Aug 16, 2004

1,011

0

• May 11, 2007

• #5

You can set them in the sun for a day and it will help to shrink them back down a good amount.

Also, applying a little vasoline to the oring can help hold it in place during assembly.

But in the end, new is the right thing to do.

 

B

bk250

Member

Sep 6, 2006

26

0

• May 13, 2007

• Thread starter
• #6

Thanks for the advice. I know it is best to replace them, and I intend to do so, but was hoping to ride this week so I will try the other tips and see if that works for the short term.