Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Dirt Bike Brands - Other
cylinder hone - how to chamfer the ports?
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="SirHilton17, post: 1044172, member: 62753"] I chamfer thr ports with a "tri corner cutter" that I made... It is basicly a triangleular file, with the file edges ground off, and sharpend... It works quite nice As for honeing... I would put steeper cross hatchings than 20-30 degrees... but i maybe confused... because there is lots of measure ment you can get for determining crosshatching... I prefer 45 degree cross hatching... I get 45 degrees from the angle that they are where the cross and the x axis... if that makes since. Run the drill slow, and go in and out... To get the right amount of speed just takes practice, and be sure to use a honeing oil when you do it... wd-40 works good... [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Dirt Bike Brands - Other
cylinder hone - how to chamfer the ports?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom