My bikes usually do that and no harm ever done.huskey89 said:First when i had the clutch in after i started it and i shifted into first, it kinda jumped foward a very little bit,
You want a little play in your handle before it starts to pull cable: about 1/8" or sohuskey89 said:So i figured out how to adjust the cable but i don't know how tight to make it. What is the rule of thumb here?
If there were, we'd all be looking for new parts. Shouldn't harm anything.huskey89 said:I accidentally started it with the muffler plug in once, any harm from that?
Clean and adjust chain periodically; clean and oil filter ever few rides; change transmission oil ever couple of rides (about 8-hours of running for me); eyeball everything before every ride; After about 20 hours or riding, it is a good idea to pull the cylinder and visually inspect the piston, cylinder and rings and measure them.huskey89 said:What regualar maintenance should i do to the bike? (stuff like every ride or every few hours)
You're always pretty safe with 32:1huskey89 said:And what oil/gas ratio should i use for this bike?
flying flea said:A Husqvarna CR 125? Isn't a CR honda?
whenfoxforks-ruled said:Chrome moly swingarm? Maybe not that expensive, if you can find a decent one.
huskey89 said:well it is definitely not an ugly weld from the factory, it was definitely at one time broke completely. the weld looks like it was a home job and it is only one one half of the swing arm, outer side. Could a professional do a good job reweldding this?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?