Flex ball hone or nylon bristle hone?

I'm hearing more and more about the nylon bristle hones. Was wondering if Eric or anybody else has had any experience with them and could add some advice?

Thanks,
Tony

From Wiseco, the bristle type of hone. I'll let you know what the hone job looks like and how much of the glaze it took off the cylinder.

What I meant to say was,

I ordered a Flex Hone abrasive bristle hone from Wiseco. When I get it and try it I'll report back as to the results of the hone I get from it.

Just in case anyone else is interested here is the information I got from Wiseco concerning their Flex Hone abrasive bristle hones.
----------------------------------------------------------------------------------

Bulletin# ACC-0702-1

. Ideal for high-performance engine building
. Abrasive impregnated nylon bristles
. Does not enlarge bores but, removes
microscopic peaks and scuffs left after
honing
. Gives a superior plateau finish
. Safe for use in 2-Cycle engines
. Designed for platted, cast iron bores
. Full range of bore sizes available

Prices & terms subject to change without notice
New Product
Nylon Flexhone Brush
45-57mm Nylon Flexhone Brush W6075 $42.01
57-70mm Nylon Flexhone Brush W6076 $43.44
63-76mm Nylon Flexhone Brush W6077 $54.51
76-89mm Nylon Flexhone Brush W6078 $56.79
89-102mm Nylon Flexhone Brush W6079 $56.79