Flipped out!

Well, it finally happened--looped her out on the hill next to my house. I guess it's getting good power. ;) Snapped the rear fender off at the bolts and crushed the silencer like a soda can. The silencer was repaired by beating a steel pipe through it with penetrating oil. The rivets ripped right out of the metal on the PC silencer---ground them out, jammed it back in and reriveted and sealed w/gray epoxy---looks pretty good. Now the question> About 3" rear of the air box the frame was bent about 4" up and to the right(the part where the silencer, seat bolts and fender bolts go in. I heated it up with a propane torch and beat the heck out of it with a hammer---bent it almost all the was back---need a little more before remounting the parts. Is this the best way to do it or does someone have a better idea. MY butt hurts!!! DOH!

Hey John, Bought this bike from Gatorkdx about three months ago. It's a 1990 kdx 200. The top end had been done just prior to purchase. It has stock 13/47 gearing and Michelin s12's fr and rr. The power---it's all in the jetting. It has a pc pipe and silencer, Boyesen reeds, no airbox lid and intake completely sealed w/blue rtv and a good clean air filter. When I first started working on this thing it had a stock needle valve, 150 main and 45 pilot---ran for $hit. WOT was all it would do and spooging like a Texas oil well. Had pilots on hand 35,38,40,42 and needles(Sudco) bel, bem, cel, cek and 148, 152 mains. Took about two weekends to get it right(a couple hours per). The carb is stock and spotless. Current jetting is 38 pilot, cel top clip and 152 main. From idle to WOT this thing pulls like a mofo. Have to be careful on hard ground--like yesterday on the grass--'cause there's no wheel spin. The bike will stand straight up in the first four gears using throttle alone, even with my fat 190 pounds sitting as far forward as the seat allows. What are you running and how is it set up! When you get the jetting dialed in it's a whole new bike. Kinda like listening to a clock radio and then sitting in the sweet spot with a nice stereo system----NO comparison!!! PM me if you want to talk off the board at jay.cicone@raymondjames.com. Thanks for the response.

Got 3 foot steel pipe and bent it back to aLMOST PERFECT WITH A PROPANE TORCH. Slapped a spare purple fender on it and--bam--looks like nothing happened. Whew! that was fun. Now back to your regularly scheduled broad programming! :o