Reply to thread

Message: [QUOTE="speedyts49, post: 668619, member: 32715"] I built a leak down tester today per Phil's instruction. I found the leak to be at the rear on the cylinder base. When I removed the reed cage I saw the piece of gasket that should of been under the cylinder flapping in the wind. The part has been ordered(again). I used a 2" test stopper, a couple of pieces of pvc, an old innertube valve and my bike pump. The exhaust port is 1.8" and the intake boot is around 1.6" so the plumbing supplys worked pretty good. thanks all, tom :) [/QUOTE]