Reply to thread

Message: [QUOTE="rmc_olderthandirt, post: 1173972, member: 68872"] Okay, you are holding the carb upside down so reference points might be inverted here: In this position the "highest point" would now be what is normally the bottom of the float. Or are you measuring the gap between the float and the gasket surface? I don't know your bike so I don't know which is correct. On my YZ-125 the measurement is from what is normally the bottom of the float. I would say that to more than double what it was (4mm to 9.5) would be a MAJOR change so something was wrong. I also would recommend that you NOT adjust the float level to make mixture adjustments. Rod [/QUOTE]