Foot peg assemblies

[Tom68]

Foot pegs pins and mounts are flogged out on my 250, is there such a thing as a complete assembly? I need to cut the old mounts off the frame and replace the lot.

 

[Joburble]

Can't you just weld up the mounting holes and then re-drill them?

 

[Tom68]

Yeh, but the tabs aren't parallel anymore so I'd have to weld them up and reshape.
The frame bracket is forged and I reckon after welding may be hard to redrill, also worried about fatigue.

 

[Joburble]

Yeh, but the tabs aren't parallel anymore so I'd have to weld them up and reshape.
The frame bracket is forged and I reckon after welding may be hard to redrill, also worried about fatigue.

Don't worry about fatigue, most people are fit enough to drill a couple of holes and it shouldn't be a problem.

I'd weld, drill and reshape them, tabs and all. If concerned about fatigue just give them a good visual inspection, they should be fine. As they are made of steel you'd see a fatigue issue before the mounts decided to break off. All just my opinion.

 

[Tom68]

Don't worry about fatigue, most people are fit enough to drill a couple of holes and it shouldn't be a problem.
.

...................... :laugh: :laugh: