Reply to thread

Message: [QUOTE="canyncarvr, post: 633539, member: 16552"] It's not a matter of taking something off what was previously there. You're subtracting from an unknown quantity so you'll get an unknown result. Figure it from the other direction. From the top of the spring to the bottom of the cap (spring in the fork, fork collapsed, cap screwed on fully extended rod) measure X. Subtract the thickness of the two oem washers (3mm). Add to that figure the amount of preload you want to get the spacer length you need. So, if X=60mm and you want 15mm of preload, your cut spacer length would be (60-3+15=) 72mm. **corrected** The pvc you got from frp isn't anything special. If you goober it somehow you can pick up another piece of it from any store that deals with plumbing stuff. [/QUOTE]