Reply to thread

Message: [QUOTE="97cr250, post: 859661, member: 57762"] Thanks for the tips...I already tried all the steps you just mentioned. :bang: I have been calling repair shops and trying to get some input. Some have said that there is something wrong other than the sealing surface between the head and cylinder...but have no input as to what. I have heard that if the head is over torqued, it will cause this type of leak. I ordered a new gasket and will be trying to torque the head to spec (17 - 21 ftlb) I know that I torqued the bolts by hand more than spec calls out for, trying to stop the leak. [/QUOTE]