Originally posted by dirt bike dave
I think the screw you are talking about is a left hand thread - go clockwise to loosen.
Originally posted by jdbrusch
the screw is just there to keep the collar in the cylinder,use the gasket from that cover to make up a plate that will cover the collar out of thin aluminum,drill the 3 holes for the mounting screws and drill a extra hole for the collar,just drilling it big enough so that it fits over the smaller portion of the collar,when you install the plate it will slide over the collar and hold it in place,you may want to drill a small hole in the plate to the left of the collar it will act as a breather hole for the little space there.Make sure you file the left over screw and easyout flush with the surface of the cylinder.Hope I explained this ok.Good luck :thumb:
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?