Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
how do you put brake fluid in brake line and caliper?
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="oldguy, post: 1159714, member: 16965"] When I do it I always start filling from the bleeder valve and reverse fill/bleed the system. I made my own bleeder from a large hypodermic needle (like the ones used on farms) that holds about 100cc. I attached a tube that is the same size as the bleeder nipple to the part where the needle would normally be. I fill the hypodermic with fluid, place the tube over the nipple, open the valve and pump the fluid in then close the valve. Repeat until the reservoir is full and then replace the cover. Next step isn't required but will firm the lever up- pump the lever to set the pads against the rotor and while the lever is squeezed use zipties to hold it in and leave it overnight. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
how do you put brake fluid in brake line and caliper?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom