how to remove small KIPS bearings

G

gertie6car

Member

Apr 12, 2008

16

0

• Jun 1, 2008

• #1

Hi, anyone got any experience or tips to remove the two small bearings in the crank case for the KIPS shafts? Cetre holes are tiny! can only think of welding a threaded bar in and using a bar across cases and wind it out using a nut. seems a bit ham fisted and am worried about damaging cases . Anyone got any ideas?

 

G

glad2ride

Member

Jul 4, 2005

1,071

1

• Jun 4, 2008

• #2

blind bearing puller?

 

B

btm1948

Member

Jun 4, 2008

97

0

• Jun 4, 2008

• #3

ya they make bearing pullers that is the easyest way

 

G

gertie6car

Member

Apr 12, 2008

16

0

• Jun 5, 2008

• Thread starter
• #4

Thanks for your replies, one is an 8mm and a puller will fit (not that i have got one) the other is 6mm and I believe that is too small for any pullers i have seen advertised. Cheers

 

G

gertie6car

Member

Apr 12, 2008

16

0

• Jun 7, 2008

• Thread starter
• #5

Hi, got then out by welding an 8mm and 6 mm bolt into then and placed a suitably drilled flat bar across the case faces and tightened up a nut to pull them out. Came out as easy as a hot knife through butter!! LOL