Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
how to tell if the crank seal is bad????
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="reelrazor, post: 846366, member: 54546"] YOu need to start with the basics. Clean the carb, well. Air filter too. Eye the reed valves while you have the carb off. Pay special attention to the air bleed passages in the carb(opening/s at the carb throat that mix air with fuel in the pilot and main jet wells). Write the numbers of the main and pilot jet down while you have them out of the carb. [b]Remove[/b] the needle jet to clean the carb(they aint clean clean unless you do). Check where the float level is before you remove the float/s. Note where the needle clip is placed and the setting of the fuel/air mixture screw. Armed with this info and the knowledge that the carb is clean, the reeds are good, etc. you can run it and see if it is any better. If not, you can then make a decision on re-jetting it properly. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
how to tell if the crank seal is bad????
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom