Reply to thread

Message: [QUOTE="jaguar, post: 801476, member: 19340"] For those with a stator coil that outputs a higher voltage (such as Electrex), you can bring the voltage down (the negative part of the waveform, which partly controls the timing) by connecting a series diode (1N4005) and resistor (or resistor + potentiometer) from the Wht/Red wire to the Black wire. The end of the diode with the "band" should connect to the Wht/Rd wire. If you used a 100 ohm resistor (1/2 W) in series with a 250 ohm pot you could adjust it on the fly until you find the best timing curve for your bike. Otherwise just use a 120 ohm resistor (1/2 watt) which will get you in the ballpark. [/QUOTE]