Reply to thread

Message: [QUOTE="Maverik, post: 910015, member: 59279"] Its hadr to measure accuratly, but i did it like 5 times, and came up with 6.0mm. Thats within the range they mentioned is factory spec. Im assuming you mean i should go up to 6.5 or 7.0mm? Wouldnt that actually alow more fuel into the bowl by closing the valve later? Or do i have it backwards? Its hard to go by the directions they give in the manual to measure float height, they tried to show it, but it just isnt clear enough or Im to dense to understand it. The tab on the float assembly is almost touching the needle on the valve as it is because of that clip they have holding it on the little tab. [/QUOTE]