Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
installing Rekluse questions
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="zio, post: 895876, member: 19332"] Installation went well. It took me a little over an hour, not including gathering up all the tools & reading the directions one more time. I gotta thank Kevin at erider for the install tips. He recommended making a cutout for the clutch basket out of an old sheet or cloth. I used an old tshirt, with the hole cut a little smaller so it would stretch tight around the basket. No nuts or balls fell in the case. Also, I read the directions several times before starting. The only little fudge I did was measuring the gap between the top steel & friction plates: Directions call for .030 - .042 or something, and one set of feeler guages went up to .026, the other went up to .032. So I took both the biggest ones, stuck them in 180 degrees apart, and they both were just barely tight. I swapped them around, and got the same (duh). Now I know that the thicker guage was tipping the clutch plates to be tighter on the thinner guage side, and maybe the difference is the actual clearance, which would be .029. It had to be close enough. I'd guess it was a little more clearance than what the directions called for, so I had to be in the ballpark. I've never used feeler guages before, but I think I understood what they meant by "still able to move in and out, but with some friction". And with the torque wrench only went as low as 10 ft/lb. And torquing the first m6 bolt to 96 in/lbs, converted to 8 ft/lbs (I got the line just below the 10 mark), just felt like a lot, so I never went that far with the rest of the bolts. I would not have done them that tight without the torque wrench. I did the warm up procedure, and I'll be damed- it worked! Did the 20 cycles of start/stopping, then went for a short ride, and damn. It works great. I can't wait to try it tomorrow. Gonna do a local D36 harescramble. It should be extra sloppy, so this will be a good test. From my 5 minute test ride, I can tell I'm going to like it. Since I was never much of a clutch featherer when engine speed got too low for a gear (I'd usually just downshift), I really noticed a difference lugging around in 3rd. I know there's more I'll appreciate, but I'll save it for a ride report Monday morning. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
installing Rekluse questions
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom