Reply to thread

Message: [QUOTE="Brandon H., post: 1373695, member: 104478"] Hmmm ok, so now that I have everything split, I will be getting new bottom end bearings and gaskets tomorrow. I plan on getting the engine done tomorrow. This engine uses a gasket between the 2 center cases, should I apply permatex ultra grey to the gasket aswell or just leave the gasket plain with no gasket maker??? Also what kind of gasket maker can I use on the other side of the case (clutch side, but not clutch cover). Also I know in the automotive world, and from building race cars with my dad, we used a chap stick on the gaskets to keep them from sticking on Holley carbs so changing jets in the pits before a race was easier, think it will work here and make future gasket removal easier???? [/QUOTE]