Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
KIPS Kuestions
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="sjp, post: 1165949, member: 74306"] Had a '92, now rebuilding an '02. New plating, Wiesco pistons Boyesen reeds and so on. The KIPS is a little different than previous, but not impossible. After assy. just how 'smooth'' should the movement be? When I turn it by hand it seems tight. Applied the right lube to all required points, all fasteners are to specs, even replaced the seals in the jug and put a new o-ring on the exhaust valve arm. It just seems tight, now maybe the engine heat and operating temp will loosen things up. But I would like some input before I put all back together and find out I going to do it again. 2nd Question - About the KIPS shaft into the motor. Exactly how does it come out. I removed the screw and pin. Does this come out without taking the engine part? I would like to inspect the bottom section. Thank you in advance for your support. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
KIPS Kuestions
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom