Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
KIPS Kuestions
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="sjp, post: 1166240, member: 74306"] Thanks for the reply... And after more research I found that there may be problems after getting the bore replated with some changes to the surfaces that come in contact with the moving KIPS parts. I'll have to go through the topend again and check surfaces and my KIPS pieces for wear. After going this far I am going to pull the right side cover and look things over. When I took the screw and pin out of the KIPS shaft into the engine I did pull it up, which most likley disengaged the bottom. Might not have been a bad move in the long run, if I rotate the shaft it looks like it's bent. So, I'm going to go in and make things right. Again, thanks for your input. [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
KIPS Kuestions
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom