Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
kx112 jetting help
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="SAPPER, post: 1363609, member: 99815"] We just finished my sons kx112 build. Trying to get a base jetting setup. stock pilot is 45. main is 138. On and initial run on the stock stuff cause I know that the kx100 is factory rich. It was pretty lean. So I went up 1 size on pilot (48). Then to get some color on a new plug went to 145 main, then 150. 150 seemed to get a dark gray, gettin to brown. The needle is still at 4th down. The main problem is it loads up if it idles for a few seconds then will clear up if I hold it wide open. BUt it also lost all top end rev. It's lacking alot on the top. If anyone out there has or had one, I'd just like to know what you had for jetting. My el. is 800'asl [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
kx112 jetting help
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom