Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Linkage Bearings and Swingarm.
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="Kyleb15, post: 1005383, member: 56354"] Hey guys, my rear suspension has always felt really stiff. I have had recomendations from the board to check the bearings. And so I did. What I found was that the bearings were shot. The needles literally felt out on all the linkage part. I have just a few questions. 1. Are there outer races that have to come out of the linkage? Are they pressed in? 2. When hammering out the seals, i broke things on the inside of the linkage that almost looked like C clips, but the dont have a notch, they are a complete O. What are these? 3. I am going to get the shock rebulit while at it, and at mxtechs site it says 89.99, does anyone know if that include parts, and labor? 4. There seems to be no bearing or bushing in the engine, where the swingarm bolt is supposed to go thru, is there supposed to be? Thanks, and it is a 2000 YZ 125 [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Linkage Bearings and Swingarm.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom