Reply to thread

Message: [QUOTE="canyncarvr, post: 221154, member: 16552"] [b]Grease it, grease it summore..and then..[/b] Grease it! While the pivot shaft/sleeve connection is NOT a bearing surface, it is still metal-to-metal, and will corrode itself stuck. When you get to the reassembly part, besides the bearings themselves, put a good deal of grease on the pivot shaft and the inside of the sleeves, too. yeah..most of it will get scraped off during install, but a decent lube-job will prevent it from sticking next time. Same goes for wheel axles!! At this point, it'll be a matter of 'sufficient' pressure, solvents or heat. A 2# sledge will work much better than a 16oz hammer.:eek: Wear your safety glasses when you're wailing on it!!!:ugg: [/QUOTE]