Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Dirt Bike Brands - Other
lower end rebuild
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="2stroke, post: 1182388, member: 25668"] I also use a bearing puller. You can get a "blind side" puller set that can pull the bearings without damaging the seals, but I use a home brewed item to do the job. Im guessing this is the first time you've done this, so i'll throw this in too: When putting it back together, it is helpful to put the main bearings in the freezer for a few hours, and when you are ready, put the case halves in the oven at about 350 for about 10 or 15 minutes. that makes putting the mains in much easier. Later, put the crank in the freezer, and take the gear side case with the new bearings installed and put it in the oven. Place the crank in the gear side case (with the transmission in it), and then freeze that whole assembly and heat the clutch side case and drop it on. Should take only very light taps with a rubber mallet to do it. Also, Ive had older units go together so that the crank would not turn freely, and I thought I mangled something, but all I had to do was center the crank somewhat using the crank case puller to nudge it. Good luck! [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Dirt Bike Brands - Other
lower end rebuild
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom