Reply to thread

Message: [QUOTE="WaltCMoto, post: 586492, member: 21177"] This was my experiance on a 97 kx250. the main bearings ( for the crank) are light to medium pressed in, so you take a small home propane torch and heat up the case on the outside where the bearing is so the aluminum heats up and expands, releasing the bearing. Dont try to get them red hot, just 5 minutes moving the torch around will do. aluminum growes pretty quickly with heat. Then when its hot, pry the cases apart carefully as so not to damage between the cases. hope this helps. Walt [/QUOTE]