Reply to thread

Message: [QUOTE="Kawierider, post: 586819, member: 23643"] I jsut split my cases on my 85'. I made puller and bent it....I ended up using a big huge thinck steel puller to seperate them....and it still wasnt easy...On my bike the bearing stayed on the cranck and pulled out of the case. I then had to have the dealer press it out of the other side of the case while they rebuilt the cranck. the same thing happened over there too. Buy a good quality, thick, thick steel puller. make sure that you screw it in evenly on both sides. Then tighten it down. I used a rubber mallot to tap the shafts in the trans and the cranck to make sure it didnt hang up on the seals. Make sure the cases seperate evenly to ensure they dont crack. Have fun, jsut be careful, good luck Tim [/QUOTE]