Reply to thread

Message: [QUOTE="Brit Chris, post: 978993, member: 62977"] Hi All, Hope your are all good I'm looking for a bit of advise i have just taken the top end off of my bike and there is no exhaust valve set up ( power valve) i have tried in vane to get a power valve set up and i was just looking for advise as to if i plated and welded the ports where the power valve should be would it harm the engine. The bike runs fine and has plenty of power but i was wondering if i did the above it would give me even more power. Thanks in advance Chris :bang: [/QUOTE]