need basic carb help

I have not tuned my carb in years and lately have been riding a lot slower since my 6 year old is now following on his little PW50. I do not have low compression and have no reason to think there are any mechanical issues. I don't have any real concerns with the way it responds to the throttle; however, I don't really know what I am looking for. I use to run 50:1 oil ratios (Amsoil and Mobil) and have recently begun to rethink that after speaking to several professional engine builders (rebuild on a KTM 50SX that will be a Christmas gift). I switched to Motul 800 and went back to a 32:1 ratio. I am not positive but I think my needle use to be one position leaner (#2 clip) in the past but I changed it to a little safer position to begin with. I have solved one problem...I would get a fairly good bit of spooge (but no real smoke) while riding since my carb was too rich. I didn't have any real spooge after yesterdays ride. It use to run down the outside of the silencer and there was no "trail" present at the end of the ride. My new problem is smoke. It will now smoke whenever I briskly twist the throttle and smoke a good bit at that. It does this in the low throttle settings. I know the fuel/air ratio was leaned by going to 32:1 and I am thinking the smoke is due to more oil being present. Is this correct or do you think maybe it is too rich on the pilot or needle (or both) and loading up on the bottom which leads to the smoke when the throttle is first twisted?

My current bike is a 2005 KDX200 with the following mods:

air box lid removed
ProCircuit pipe and silencer
misc. suspension and protection goodies



My carb is currently setup with:
42 PJ
155 MJ
stock needle in #3 clip
AS 1.5 out
NGK BPR8ES plug


Environmental factors:
1000' elevation
85 - 90 degree temps



Should I go one step leaner on the PJ? Try the #2 clip on the needle? What would you'll recommend?