Reply to thread

Message: [QUOTE="Brandon H., post: 1370047, member: 104478"] Ok, as some of you may know already, I scored a 1994 YZ 125 for $80. It needed a stator (which is one its way via UPS thanks to Ebay), and other small TLC. So far the bike itself has been overhauled and is ready to go, so now im doing motor work. The threads where the nut goes to hold the flywheel on the crank is all boogered up (not my fault). I will need to get a die and try to recut the threads. I need to know what size it is. I downloaded a sheet and printed it to scale off boltdepot.com . According to the sheet, its either 3/8 - 24 or 10mm x 1.25 Which one is it?? I am leaving in a few hours to get a die. Also, if I need to go one size small, what size should I get??? I also need to get a new nut and washer for it (because the owner didn't have it. I know bikebandit.com has em, but can I just buy a nut and washer from lowes?? Any specific kind?? [/QUOTE]