Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
New KDX'er questions
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="Hellbender, post: 842508, member: 56559"] Everyone, thanks for all the good tips! trailryder---I'll look for some #'s on the pipe, thanks. I still have my KDX200 so I could just swap the carbs at no cost, IF it would be the right thing to do. I wonder if I would get the best of both worlds (33mm & 35mm) with the larger carb w/ the divider plate??? I wasn't sure if the torque ring worked with aftermarket pipes, you would think the "torque" pipe would already be designed for the lower RPM power. I have a skid I'm taking off the 200, but I need to weld on more side protection. I was thinking the same as you on the port roughness, but wasn't sure on a 2-stroke. I'll not mess w/ the timing now. The reeds seemed like a good $35 gamble. skipro3--So you would wait on the new reeds during the rebuild???? Break it in, adjust everything, then do the airbox mod, and do it all again, add the reeds, do it all again, etc, etc? Seems it would be easiest to do all the mods, start with the jetting recco'd in this site, and go from there. Am I missing something? Who makes the flywheel weights? Would they slow down the throttle "snap" to lift the front tire at low/slow speeds? I guess I will pass on the CEET foam if it's harder, it seems I always end up sitting on the rear part of the seat that only has 1/2" of pad (I'm tall). I may have to make my own. I won't be riding hard for another year or two (as my boys progress from thier Yamaha TTR125's) so I'll sit a lot, and I have a bad lower back so I need the "cush". I wondered if the ring would help w/ a torque pipe. Thanks for the advise and the welcome! John Harris--The only reason I thought of the carb swapping is I have one now at no cost. Thought maybe the divider plate would make up the difference lost to the smaller carb. My boys and I have been having a blast, I just bought my wife an XR100R 2 weeks ago and she likes it, too! motorider200--I will do a little research! Thanks again! [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
Dirt Bike Discussions By Brand
Canadian Daves JustKDX
New KDX'er questions
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom