Reply to thread

Message: [QUOTE="WoodsRider, post: 1198901, member: 16545"] Try this simple program. Make sure to clear the memory first. Speeds: 1. 24 TO 3.20 2. WAIT = 003 3. JUMP TO 0.00 4. 24 TO 4.00 5. WAIT = 003 6. JUMP TO 0.00 7. 24 TO FINISH Resets: 1. 3.21 TO 0.01 2. 4.01 TO 0.01 Turn the unit on and bump mileage up to 3.19 and wait the ~8 minutes until the clock catches up then bump the mileage up to 3.20. The unit should flash between the display and a countdown of the wait time from 3 minutes. When the wait is over, bump mileage to 3.21 and it will go to 0.01 and the display will resume normal operation. Bump mileage up to 3.99 and wait the ~10 minutes until the clock catches up then bump the mileage up to 4.00. The unit should flash between the display and a countdown of the wait time from 3 minutes. When the wait is over, bump mileage to 4.01 and it will go to 0.01 and the display will resume normal operation. Takes about 30 minutes, but I tried it with my unit and it works fine. My problems have been forgetting to program in the jump to zero as a speed change after the wait time, forgetting to offset the reset mileage by 0.01 on BOTH reset entries and forgetting to enter a speed change after the last jump to zero. A few guys I ride enduros with use Watchdog computers which, I guess, are easier to program. One of my buddies, who rides 50+, uses a watch and odometer and does just fine. [/QUOTE]