Reply to thread

Message: [QUOTE="glad2ride, post: 1388688, member: 62076"] Stock is four bearings. Pivotworks is two. "Bearing - 20 x 27 x 30 Needle" [url]http://www.pivotworks.com/documents/support/PWSAKK11020_26ED50E1EEA1C.pdf[/url] Since the stock bearings are: BEARING-NEEDLE,TA202715ZE, or 15mm wide, then I would hope the new seals protrude inward more than the stock seals. If the seals protrude inward 3 more mm, then that would take up the stock 6mm gap. Put the new bearings in with the nimber facing outward (away from the center of the bike, not facing each other). [/QUOTE]