Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Powervalve slaming exhaust port
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="NO HAND, post: 166763, member: 18937"] I noticed on the last rebuilt that the powervalve flaps are hanging lower than they should in the closed position. It is so far low that the flaps are gouging in the floor of the exhaust port, just behind the bridge. Also when the pv is closed, there is a gap between the upper edge of the exhaust port and the upper edge of the powervalve flaps, so much it is hanging too low. Once in the open position, it goes where it is supposed to and works fine. I rechecked everything to make sure it is properly assembled. What is causing that? Could I use a round spacer on the stop pin on the side to reduce the travel in the closed position? Thanks! [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Powervalve slaming exhaust port
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom