Home
Basic Dirt Bike How-To's - Video
Dirt Bike How-To's - Video
Living The Moto Life - Video
Bike Tests | Shoot-Outs - Video
Forums
What's new
Latest activity
Log-In
Join
What's new
Menu
Log-In
Join
Navigation
Install the app
Install
More options
Close Menu
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Primary Drive Gear Bolt Tightening, how w/o moving crank?
Reply to thread
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="joeym4130, post: 1198238, member: 71994"] I am putting my bike back together for the 1st time, :) I am at a point where I am to put the primary drive gear back on the crank shaft and I have everything ready and waiting, but I'm not sure how to tackle the problem of torquing the bolt to 50ft/lbs without spinning the crank around.. I'm sure there is a tool to buy to do it, but it'd be nice to be able to without spending more for a one time thing I tried a strap wrench on the gear as I tightened the bolt and it worked until I had to actually put a lot of pressure, then the rubber strap just kept moving/falling off the gear. I dont even think I made it to 30ft/lbs. Any tricks? Thank You! [/QUOTE]
Verification
Which ocean is California closest to?
Post reply
Forums
MX, SX & Off-Road Discussions
Dirt Bike Mods & Maintenance
Primary Drive Gear Bolt Tightening, how w/o moving crank?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
Accept
Learn more…
Top
Bottom