Pulled the cylender an found build up on the wall. 12:00 being exaust this was at 10 or 11 o'clock, what would cause a piston to "Shead" or leave deposits in a certain area?
Overheating?
I did get a lower ammount of coolant than expected when I cracked the jug.
The Cap was immaculate and the jug is smooth aside from a one inch square area near the port. It is raised and can I use a Hone to remove the depsit or is it time to punch it?
Overheating?
I did get a lower ammount of coolant than expected when I cracked the jug.
The Cap was immaculate and the jug is smooth aside from a one inch square area near the port. It is raised and can I use a Hone to remove the depsit or is it time to punch it?
Last edited: